March 27, 2016
I am putting a console in a Tracker 1448MVX Grizzly. It now has a tiller for setting. Has any one out there done this, and how big a job is it. The throttle controller looks like the hardest part. Is this doable in your own garage.
Reply
March 27, 2016
I have a Tracker 2016 1448MVX with a 2016 25HP EFI Mucury motor with tiller drive. I won't to install a console with steering wheel and throttle controler. I will continue to start the motor with the starter button on the motor. Is this something I can do at home as the dealer won't s a minimum of $1500.00 dollers. Please reply ThanksCorky
Reply
April 7, 2016
Trying to run a new transducer cable/power/ground. How is easiest way up tunnel. Keep getting hung up with electrical snake.
Reply
April 16, 2016
I have a 2002 nitro. When I'm sitting in the boat facing forward, is the trolling motor battery behind me on the left or the right?
Reply
April 18, 2016
Yes I have a 2001 Nitro NX 750 sometimes a fuel gauge works and sometimes it doesn't have been riding on the lake with a lot of waves and whether the pounding may be taking a toll on it sometimes it works sometimes it don't I check the wiring everything looks good and solid under the day can you please steer me in the correct way to diagnose this problem
Reply
May 1, 2016
White light on my navigation works but red and green dont then on my aerator pump noise coming from under dash and can't hear my pump running it's on a 2005 16.5 bass tracker
Reply
-
Tom
October 25, 2017Make sure your light is plugged into the bow and not the stern.
Reply
May 8, 2016
No spark at plugs. Console has power trim and ignition working. No horn, lights , gas gauge. Checked under console for fuses or a link. 18′ 2010 Bass Buggy
Reply
May 25, 2016
i have a 2005 tracker v16 and the livewell pump quit working. Replaced all fuses ,but didn't do any good. Any ideas?
Reply
June 16, 2016
I put an entire new deck and carpet on my 1984 tracker tournament V-17 and after putting everything back together my nav lights, bilge, and other electronics are not working at all does anyone have any suggestions? Would really like to keep it out of the shop
Reply
June 19, 2016
I have 92 tracker pro 17 evinrude 50 just got it I need the wiring diagram for the lights, pumps and evering, plus how many pumps and plumbing as well PLEASE bear with me, im a 20 yr vet from 72-92 leagally blind and have tunnel vision meaning looking thru a straw at 10 feet can you help thanks ray
Reply
June 27, 2016
I have a 2004 q5 runs great them out of now where it starts back firing pop and spit you can turn the key off and it'll start right up and run again until it does it again. Any help???
Reply
-
Jim
August 28, 2016This sounds like high pressure in the lower gear resevour. What happens is the boat runs fine untill the lower unit gear lube gets hot and builds up to much pressure. The engine will pop and die. The pressure then releases. Starting It will then start and run for a bit longer before doing it again. FIX … Drain the lower unit gear lube and refill the resevour fully. The original cause is usually low gear lube level.
Reply
June 28, 2016
2013 Tahoe 215 Deck Boat 4.3 merc
Will not start- dash lights & accessories not working. Checked fuses/ battery good/ blower works
Is there a circuit breaker-where?
Reply
-
John
June 21, 2019Have you found the fix? We are having the same problem
Reply
July 30, 2016
I have a 1991 bass tracker I got it and some of the wires under the console are unplugged from the switches does anyone know what wires go where?
A picture of the backside of the switches would be great
Thanks
Reply
October 5, 2016
My live well pump kicks on for no reason. Help me please.
Reply
-
Barry
April 12, 2019
March 11, 2017
I have a 2005 nitro 750sc…does any one have a diagram of the fuse panel too tell you what each fuse is for….my fish finders wont lite up…every thing else on the boat works…now its not in the water as its winter time here in the east coast of Canada…and I am a the new owner of the boat so I never had it in the water yet…I have the 12 volt starting battery all hooked up…how ever I have not hooked up the 24 volt system for the trolling motor as I'm sure these fish finders do not run off those battery's and help or leads would be appreciated…thanks…Tom
Reply
no power from engine, trim and ignition switch. Battery new, 20 amp circuit replaced still no power
Reply
April 14, 2017
I have a 2017 Pro 190 TX and I want to put a bow mounted fish finder on it. What is the best way to pull the transducer cable back to the transom? What panels are removable for easier access? I am handy but don't want to screw up my new boat.
Reply
April 14, 2017
I have a 2017 Pro 190 TX and I want to put a bow mounted fish finder on it. What is the best way to pull the transducer cable back to the transom? What panels are removable for easier access? I am handy but don't want to screw up my new boat.
Should have clicked the follow-up comments button
Reply
May 17, 2017
I have a 2001 Bass tracker 17 ft that the engine has been swap out and a 2004 yamaha jet drive was put on it.Need to no how to wire all the gauges
Reply
June 11, 2017
I have a 2008 nitro 750dc, wife bought me a lowrance hook 9 for my B-day I mounted it up front noticed under trolling motor panel there are 2 sets of spare wire one purple/black & the other red with black stripe/black can I use a set for my power?
Reply
Just got a used 2013 Tahoe Q4sf and the lowrance Pro4 fish finder does not work, I think it is in conflict with the transducer for the in dash depth finder. Do I need to rewire the fish finder off the master shutoff? This way the in panel will be off and the minKota fishing motor will work together with the master switch off. Also would like to know where the transducers are located. Any help would be appreciated.
Reply
September 2, 2017
I was so glad to find the wiring diagram
Do they sell the harness for 1990 pro 17 bass Trackers?
Reply
September 4, 2017
Have a 98 tracker pro team 175 my dash lites were working now stopped why.
Reply
September 24, 2017
Main power from battery to new fuse block what size inline fuse do I need,the block says no more than125 amp, but that sounds high to me,yes no, or please tell me the size,,its a pro team 175. 1998 tracker
Reply
September 27, 2017
From batteries main power to the newfuseblock it said max fuse 125 amp, what size do i use.
Reply
December 28, 2017
1993 Bass Tracker Pro 17 40 HP Evenrude.
Just got the boat 1 month ago. Previous owner
started it up motor ran good. 1 week later I started
It at home with water running through engine.
Ran good. Repaired a few minor things and decided
to take it out the following Saturday.
Saturday: Motor just spins over. Sounds to me like
no spark or no gas. Disconnect water from motor.
Move boat close to my work shop, remove plugs
Clean and reinstall. Motor was on the stand on rear
I decided to put it down remove stand and use trim
to lower motor. After I let motor down Lost All Power.
Checked battery wit multi-meter 3.9 volts Both Batteries.
Charged battery's over the next week, checked fuses
Wire connections and put a new ignition switch.
Still No Powet…. Any Help will be much appreciated.
Thanks for your time Reading.. Jon
Reply
February 9, 2018
I have a 2012 tracker Pro Team 190 with a 115 Optimax engine. I am trying to install a tilt and trim gauge. Everything says the sender wire from the engine is brown and white. And that is correct. The problem is, at the connector that transitions from the motor to the boat console, I lose the brown and white wire. it apparently changes to something else and so far my guessing has been wrong. Have not been able to find any help with this. Thoughts???
Reply
-
James Keown
May 5, 2019I am trying to install a trim,tilt gage on my 2012 175 60 hp 4 stroke. I am losing the brown and white wire under the dash.does it turn to another color?
Reply
April 21, 2018
I have a Tracker Tahoe Q7 2002 6.2 MPI. I need the wire diagram for under the dash to wire all gauges and switched including the key switch. Can you please help?
Reply
May 20, 2018
Wire color code for power trim and tilt on bow switches for a 1988 bass tracker tournament v17
Reply
-
Jay
July 12, 2019on my 2001 tracker I have a red for power and a green/white and a blue/white for the trim.
Reply
June 1, 2018
I have a 27 foot sun tracker and the horn won't work and the boat won't even turnover. I think it is a wiring issue. We're can I get a picture of the wiring harness under the steering column.
Reply
July 4, 2018
I have a 1988 Tracker pro 17 just recently acquired. Its in great shape for the most part but having some electrical issues on the console. The voltage, tach and PSI indicator work. However the bilge, aerator, lights, depth finder and radio do not. Check fuses and for loose wires and found nothing. Everything seems to be connected as should be under the console. Any help appreciated!
Reply
December 28, 2018
how do i wire a 1983 bass tracker 1 i need a diagram if anyone has one
Reply
April 9, 2019
I just purchased a 2018 Pro Team 195 TXW and installing a bluetooth power amp. I need to connect it to a wire so when the key is switched on, it activates the amp. Does anyone know which wire I need to slice into?
Any help would be appreciated.
Dave
Reply
April 25, 2019
I have a Bass tracker pro175 txw. At first I thought my problem was the bow switch. My motor would constantly trim up. I found the problem was the up from the bow switch, so I unplugged that wire from the switch. I replaced the switch and now the up doesn't work at all. I believe I have deduced, that the wire that connects to the up (switch) is the problem. I am trying to find out the way to replace that wire. I can't find a wire diagram for the boat and am not sure where that wire goes (connects to) other than the battery.
Can i just attach another wire to the up wire and pull it out, therefore replacing the bad wire and then connect the new wire to the switch and battery?
Thanks for any help…
Reply
May 29, 2019
12v outlet on a Tracker V18 combo is hooked to which battery? Trolling or engine starting battery?
Reply
July 2, 2019
I purchased a 2019 175 Txw all gauges are working with the exception of trim and fuel gauge the boats literally 3 hours on it for the life of me can't figure out why all fuses are ok and connections seem to be tight any advice would be enormously appreciated.
Reply
July 12, 2019
on my 2001 tracker the tilt and trim work fine off of the bow and the side of the motor but, not off of the shift swith. any ideas would be appreciated.
Reply
August 9, 2019
Anyone know where the fuse for the blower on a pro jet?
Reply
Source: https://www.tacklereviewer.com/freebies/tracker-boats-wiring-diagram
Posted by: lucianolucianosloughe0270869.blogspot.com
